Apple iBook Manuale Utente Scaricare il pdf (Pagina 46)

Page 46 of 51

On the back of the drive, locate the

two Philips head screws shown in red

and remove them. Disconnect the

cable, and note that the cable says “

TO CD ROM” This is so you don’t

confuse it in reassembly.

If installing a drive that that not have a

front “white” bezel, remove the bezel

from the drive you are removing, and

put it on the one you are installing.

See below:

Drive Bezel Replacement

The procedure for changing the drive faceplate varies by what type of drive you have.

The instructions are covered below per drive:

CD-ROM – On the top of the drive, locate the Philips head screw immediately in front

and center of the bezel. Remove this screw. On the left hand side, notice a white tab.

Push this tab in with a flat head screwdriver or other flat tool. Do this on the right side as

well. Then, using a flat head screwdriver, gently go around the bezel and pull the bezel

off. Be careful not to damage the bezel.

DVD-ROM - On the top of the drive, locate the two Philips head screws immediately in

front and on the left and right hand side of the bezel. Remove these screws. Tilt the bezel

down and off of the drive.

CDRW Drive – Notice on the top left and right of the drive there are two tabs holding

the bezel in place. Push these tabs down and out to release the bezel, and then remove the

bezel.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51

Nessun commento

Apple iBook Manuale Utente Pagina 46