Apple Xserve Intel (Late 2006) DIY Procedure for Logic B Manuale Utente Scaricare il pdf (Pagina 10)

Xserve (Late 2006) Logic Board Replacement Instructions 10

Important: Each heat sink is connected to the logic board by a small 2-pin thermal sensor

cable. Be careful not to pull on the wire as you lift each heat sink enough to disconnect the

cable from the logic board. It’s easier to reach the sensor connectors on the logic board if

you start with the right heat sink near the DIMM slots (CPU A).

Slowly lift the heat sink o the processor just far enough that you can reach the sensor cable

connector. You might feel some resistance from the thermal grease that binds the heat sink

to the processor.

Pull on the connector, not the wires, to disconnect the sensor cable from the logic board.

Lift the heat sink straight up and out of the enclosure.

Repeat steps 1 through 4 for the left processor (CPU B) heat sink.

Note: You will need to clean o the old thermal grease from the bottom of each heat sink and

the top of each processor before installing them on the replacement logic board. You will also

need to apply new thermal grease to the tops of the processors. For more information, see

“Replacing the Processors” and “Replacing the Processor Heat Sinks.”

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Nessun commento

Apple Xserve Intel (Late 2006) DIY Procedure for Logic B Manuale Utente Pagina 10