Apple Xserve (Early 2008) DIY Procedure for Processor Manuale Utente Scaricare il pdf (Pagina 3)

Xserve (Late 2006/Early 2008) Processor Replacement Instructions 3

Opening the Xserve

Loosen the thumbscrews at the back of the top cover and slide the cover back and up to remove

it. If you have diculty removing the cover, check the enclosure lock on the front panel.

Warning: Even after you shut down the Xserve, its internal components can be very hot. Let

it cool before you open it.

Important: To minimize the possibility of damage to Xserve components due to static discharge,

wear an antistatic wrist strap, if possible, while you work inside the Xserve.

Removing the Installed Processor

Note: Before you can remove a processor, you must remove the airow duct and heat sink

covering the processor.

Important: Although the images in this procedure are based on the processor farthest from the

DIMM slots (CPU B), the steps are the same if you are replacing the CPU A processor.

Airow Duct

Loosen the ve Phillips screws that fasten the airow duct to the fan array.1.

Pull up on either side of the airow duct, and lift it straight up and out of the Xserve. 2.

1 2 3 4 5 6 7 8 ... 13 14

Nessun commento

Apple Xserve (Early 2008) DIY Procedure for Processor Manuale Utente Pagina 3