Apple Xserve - Apple Xserve Manuale Utente Scaricare il pdf (Pagina 21)

Chapter 3 Starting Up AXD Tools 21

To use the Xserve front panel to start up an AXD EFI tools NetBoot image:

1 Turn o the Xserve.

2 Press and hold the system identier button and press the on/standby button.

System identifier

button

On/standby

button

3 Continue holding the system identier button until the top row of lights blink right to

left. Release the system identier button.

Top row of lights blink right to left,

then left to right.

If the two rows of lights on the front panel blink once and the Xserve resumes its

startup sequence, a rmware password is enabled. You’ll need to disable the password.

For information about disabling the rmware password, see the next section,

“Disabling the Firmware Password.”

Both rows of lights blink once.

Disable the firmware password.

4 When you release the system identier button, the lower-right light should turn on.

Lower-right light comes on.

5 Press the system identier button again. The lights in the bottom row should now be

blinking right to left.

Bottom row of lights blinks right to left.

6 Press the button repeatedly until the lower-left light turns on.

Lower-left light comes on.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Nessun commento

Apple Xserve - Apple Xserve Manuale Utente Pagina 21