Apple Xserve RAID User's guide Guida Utente Scaricare il pdf (Pagina 43)

Connecting Xserve RAID to a Host System and a Network 43

Connecting Power to the System

The ﬁnal step in preparing the system is connecting a power cord to each power supply on

the back panel of Xserve RAID.

Follow these steps to connect the two power cords.

1 Lift the small support clip on the system’s back panel, then connect one of the power cords

to the socket at the lower right of one power supply.

Note: Be sure to use the power cords supplied with the system to ensure that the clip holds

them securely and avoids accidental removal of a cord. If you received more than two power

cords, use the ones with plugs compatible with the electrical supply for your location.

2 Secure the support clip to hold the power cord in place.

The half-circle at the front center of the clip goes over the cord.

3 Connect the second power cord and secure the clip on the cord.

4 Plug the cords into a power strip, outlet, or other power source.

Note: For additional protection, connect each of the power cords to a different electrical

circuit, preferably on different power grids.

Snap the power cord retainer clips over the power cords.

Power cord retainer clip

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 91 92

Nessun commento

Apple Xserve RAID User's guide Guida Utente Pagina 43